Rockford Fosgate P400x4 Punch 4 Channel Car Amp 50 Watts Rms X 4

Rockford Fosgate P400x4 Punch 4 Channel Car Amp 50 Watts Rms X 4

Rockford Fosgate P400x4 Punch 4 Channel Car Amp 50 Watts Rms X 4

Rockford Fosgate P400x4 Punch 4 Channel Car Amp 50 Watts Rms X 4

Rockford Fosgate P400x4 Punch 4 Channel Car Amp 50 Watts Rms X 4

Rockford Fosgate’s Punch P400X4 amplifier can put out 50 watts RMS to each of your front and rear speakers, plenty of power for clean music even at high levels. You can use the amp’s high-pass filter to remove low bass from your speakers so they’ll play more efficiently. You can also switch this amp into 2-channel mode to drive a couple of subwoofers with up to 200 watts RMS each. The amp’s low-pass filter comes in handy for getting the right sound from your sub/enclosure combo. The Punch EQ2 includes bass and treble boosts, in case you want to add some boom and sizzle back into the mix. Once again, Rockford Fosgate steps away from the crowd with their C. Technology (Calibrated Level Eliminates Audible Noise) a setup system that ensures your music will sound as clean and powerful as possible. It works like this: play the setup tone on the included test CD, adjust the receiver volume until a red clip light on the amp goes out, then turn the amp gain up until a blue light comes on. It’s that simple your amplifier is now set to match your receiver’s output. When your receiver reaches maximum clean volume, you’ll get maximum clean power from your Punch amp. At quiet listening levels, you’ll hear less background noise and more of your music. If that blue light turns solid red while you’re playing music, the amp’s telling you that your source is distorting and you should turn it down, or risk damage to your gear. The amp’s built-in computer keeps tabs on the output current, ensuring that plunging speaker impedances (they change during play) or even a short circuit won’t hurt anything. Rockford Fosgate’s Dynamic Thermal Management system uses forced air to dissipate heat evenly across the amp and out through the high-mass heatsink, efficiently drawing heat away from vital internal parts. Their proprietary MEHSA cooling process maximizes the heat transfer from the MOSFET devices to the heatsink, allowing the heat to escape more readily, so the transistors stay cooler and work better. Ratings shown are for the amp photoed. Ratings may vary slightly on the amp you receive. 50 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms). 200 watts RMS x 2 bridged at 4 ohms (4-ohm stable in bridged mode). Variable high- and low-pass filter filter (50-250 Hz, 12 dB/octave). Variable PEQ2 bass/treble boost (0-18 dB at 45 Hz and 0-14 dB at 12.5K Hz). Gain setup system includes test tone CD. Test tones also available as MP3 download from Amazon On Demand, Rhapsody, Google Play, and Spotify, labeled 3sixty. 3 setup disc Punch amps and the 3sixty. 3 use the same test tone tracks for setup. Frequency response: 20-20K Hz. Dynamic Thermal Management and MEHSA MOSFET cooling systems. MOSFET power and output stages. Preamp and speaker-level inputs speaker wire to RCA adapter. Required for speaker-level input. Signal-sensing turn-on with speaker-level inputs eliminate need for remote turn-on lead. 4-gauge power and ground leads and an 60-amp fuse recommended wiring and hardware not included with amplifier. No onboard fuses when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended. 11-1/8″W x 2-7/16″H x 8-13/16D. The item “ROCKFORD FOSGATE P400X4 PUNCH 4 CHANNEL CAR AMP 50 WATTS RMS X 4″ is in sale since Thursday, September 29, 2016. This item is in the category “Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Amplifiers”. The seller is “bestsounds4less” and is located in Walnut, Illinois. This item can be shipped worldwide.
  • Brand: Rockford Fosgate
  • Model: Punch
  • MPN: P400X4
  • RMS Power: 400W
  • Channels: 4

Comments

Comments are closed.