Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

Soundstorm Evo3000.1 3000 Watt Class D Monoblock Amplifier Mono Car Sub Amp Knob

BRAND NEW SOUNDSTORM EVO3000.1 3000 WATT CLASS D MONOBLOCK AMPLIFIER MONO CAR SUB AMP KNOB. SOUNDSTORM EVO3000.1 3000 WATT MONOBLOCK (1 CHANNEL) CLASS D AMPLIFIER WITH REMOTE BASS KNOB. The lowest impedance accepted by this amplifier is 1 ohm. Amplifiers that are 1 ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 ohm load is usually reserved for serious subwoofers that can handle the power. Please note this particular amp needs a healthy electrical system including a low gauge wire capable of delivering the necessary current. Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. We use Class D in our monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass. The phase control feature allows you to adjust the speakers phase to ensure all audio signals are playing together rather than against each other. When bass notes are noticeably absent, a quick and easy adjustment to the phase control could provide the perfect remedy. If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself. Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 ohms. A benefit of strapping is less electrical current is required than if you ran [2] individual amps at 1 ohm and you only need 1 pair of preamp outputs and [1] RCA cable to connect. A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently. The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output. Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed. Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it. Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping. Variable Low Pass Filter. Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer. SoundStorm Labs (SSL) EVO3000.1. Class-D 1-ohm Stable Monoblock Amplifier. 4 ohms: 563 watts x 1 chan. 2 ohms: 1125 watts x 1 chan. 1 ohm: 2250 watts x 1 chan. Total power output: 3000 watts. Pulse Width Modulated MOSFET power supply. Wired remote bass level control included. LED power (green) and protect (red) indicators. Preamp RCA outputs to daisy chain multiple amps. 3-way protection circuitry (thermal, overload, and speaker short protection). Heavy duty aluminum alloy heat-sink. Frequency Response: 15 – 500Hz. Total Harmonic Distortion (THD). Signal to Noise Ratio: 100dB. Variable low-pass filter: 50 – 150 Hz, 24 dB/octave. Subsonic filter: 15 – 40 Hz , 24 dB/octave. Variable Bass Boost: 0 to +18dB. Dimensions: 10″ W x 12.688″ L x 2.3 H. The item “SOUNDSTORM EVO3000.1 3000 WATT CLASS D MONOBLOCK AMPLIFIER MONO CAR SUB AMP KNOB” is in sale since Monday, September 30, 2019. This item is in the category “Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Amplifiers”. The seller is “discountsjungle” and is located in Los Angeles, California. This item can be shipped to United States.
  • Model: EVO3000.1
  • RMS Power: 3000W
  • MPN: Pioneer GM-D9701 Rockford Fosgate R2-1200X1
  • Channels: Mono
  • Brand: SOUNDSTORM

Comments

Comments are closed.